DESCRIPTION
This new injected molded Vertical Grip is designed for the MPA BA Chassis System. The grip design includes a true Vertical interface with the rifle, an Enlarged Palm Swell, Trigger Finger Support Rest and the Enhanced Thumb Notch.
The grip also comes with our special grip tape for improved contact.
The interface with the rifle is a standard A2 type, so the grip, with potential minor modifications, should fit onto other rifles, carbines and chassis that utilize an A2 Grip.
Since the grip is a solid injection molded component, it can be modified without sacrificing the strength and integrity of the part. So if you need to polish, grind, sand or another method of modification, you wont hurt the grip. Just be careful not to remove too much.
This grip will fit on the BA Lite and BA-CZ455 Chassis. However, there will be a slight gap between the thumb notch on the grip and the chassis.
Reviews
-
MPA grip
I like the grip so far. Have a few others from Anarchy, MDT, Ergo, and others and wanted to give this one a try. I really like the extra material under the trigger finger, it positions my finger much better on the trigger. Grip feels solid and has a good width. My particular grip however had a very poorly drilled screen hole, it appeared to have been drilled twice with the holes not lines up very well. Lots of little pieces of debris hanging off each end of the hole as well. The top side of the grip where it mates to the chassis is obviously cut for an MPA chassis but I am putting it on an outlier Rem 700SA chassis. This causes the grip to sit just a little off vertical as the grip is molded to fit the MPA chassis and has in even surfaces on top. The can't isn't enough to cause problems or make it not fit well, it is just a little annoyance when you look at it and can tell it is not 100 percent there. Haven't shot with it yet, but don't anticipate any issues. Time will tell.
-
MPA vertical grip
Great grip with a much improved hand position over the ergo that came on my chassis
-
Solid improvent.
Great improvement over the stock grip that came with my mpa ultralite chassis. Allows for a better and precise trigger pull with a solid grip that doesn't put incessant torque on the rifle.